Safety operation rules for CNC deep hole drilling machine - News - Global IC Trade Starts Here Free Products

MOS power IC full range

SMD aluminum electrolytic capacitor

1. Work clothes must be worn before work, cuffs should be tied, scarves should not be allowed, gloves should not be worn, and women workers should be caught in hats.
2. Check the protection, insurance, and signaling devices on the equipment. The mechanical transmission part and the electrical part must have reliable protection devices. Whether the work and fixtures are in good condition, otherwise they are not allowed to start.
3. The platform of the deep hole drilling machine should be tight and the workpiece should be clamped. When drilling small parts, use a special tool to prevent the workpiece from being rotated, and it is not allowed to hold it by hand or press the hole.
4, automatic walking, you must choose the feed speed, adjust the travel limit block. Manual feeding is generally carried out according to the principle of gradually increasing pressure and decompression, so as to avoid accidents caused by excessive force.
5. When adjusting the deep hole drilling machine speed, stroke, clamping tool and workpiece, and when wiping the machine, stop it.
6. After the deep hole drilling machine is started, it is not allowed to contact the moving workpiece, tool and transmission part. It is forbidden to transfer or take tools such as tools through the rotating part of the machine.
7. When the long iron filings are wound on the drill bit, it is necessary to stop the cleaning. It is forbidden to blow with the mouth. Hand pull should be removed with a brush or iron hook.
8. With the rocker drill, there are no obstacles in the range of the cross arm rotation. Floats are not allowed on the cross arm and workbench.
9. At the end of the work, lower the cross arm to the lowest position. The headstock is close to the column and must be clamped.
10. When two or more people work on the same machine tool, one person must be responsible for safety and unified command to prevent accidents.
11. If abnormal conditions are found, stop immediately and ask the relevant personnel to check.
12. When the deep hole drilling machine is running, it is not allowed to leave the job. Therefore, it is necessary to stop and cut off the power when leaving.
13. After the work is finished, close the main gate of the deep hole drilling machine, wipe the deep hole drilling machine and clean the working place.