Traditionally, in order to set up a PLC-based FA system, it will need to purchase and install support software for various modules, then connect to PLCs and other components, start different software, and set programming for various modules.
The CX-One is a programming and configuration software integration toolkit developed and developed by Omron Corporation. This software package integrates Omron PLC, network, HMI, motion control, drive, thermostat, and sensors to support FA products.
If the FA integrated tool package CX-One is installed on a personal computer, the support software for the module is enabled from the CPU Bus Unit and Special IO Unit in the IO table, and Network configuration, setting up various connected components, can improve the efficiency of the PLC system.
The CX-One software consists of the following five parts:
Users can install all or some of the above software according to their own needs. All of the above software is not described here in detail. The unique integrated simulation functions in CX-One2.0 are mainly introduced. Everyone is using PLC and HMI when working on the project. In the previous Omron software, the ladder diagram of PLC can be simulated (using CX-Programmer and CX-Simulator). In addition HMI is often used products, Omron's NS series products, use CX-Designer production screen, can also support simulation capabilities, this can save development time and improve development efficiency. Now Omron's CX-One version 2.0 combines the simulations of the two, and without the need for a PLC, a system consisting of a PLC and an HMI can be completely and efficiently simulated. The same variables combine the two organically. As shown below:
The specific operation is as follows:
1) Open Cx-Designer software and create corresponding screen
3) Open the ladder diagram .CXP file associated with the touch screen
4) Press the start button, PLC-PT integrated simulation will be started
5) After starting, the data of the A port of the NS touch screen is associated with the data in the CX-Programmer. The data of the modified touch screen will be reflected in the ladder diagram, and the data changes in the ladder diagram will also be reflected in the screen of the touch screen. . This example circularly triggers the alarm 1, alarm 2, and event 1 to be assigned addresses 0.00, 0.01, and 0.02 in the PLC program. The temperature alarm, humidity alarm, and event 1 information can be displayed on the touch screen.
Through the integrated simulation function of PLC-PT, it can realistically imitate various working conditions of the site, and can debug PLC program and touch screen at the same time without PLC and PT hardware, which lays a good foundation for the actual debugging of the site.
Filter Choke Inductor,power Filter Inductor,PCB mount Filter Inductor,UU Filter Inductor,Common Mode Choke Filter
IHUA INDUSTRIES CO.,LTD. , https://www.ihua-sensor.com